How to Apply the new Ultra Hold Beard Setter

This is a short tutorial video where the founder, Charanjeev Singh, shares how he sets his beard using the New Ultra Hold Beard Setter.

Step1: Blow dry your wet beard. Use a hot blow dry as the heat helps to straighten the beard. Along with blow drying beard keep brushing the beard.

Step 2: Scoop out the Beard Setter and apply it directly on to your beard. Make sure the whole beard is properly gelled. The quantity to be applied varies from beard to beard/Singh to Singh. Give it a couple of days to figure the amount.

Step 3: Now use a beard brush to set the beard.

Step 4: Tie the beard tail with a rubber band. Make sure the beard tail is a bit loose as it will allow you to tuck the tail with ease. Before you tuck the beard tail make sure the beard/gel is dried. One can stand in front of the air-conditioner or use a Cool Blow, an option your blow dryer might have. It usually takes 5-7 minutes for the beard to dry.

Step 5: Once your beard is dry, tuck the beard tail and use a pin to keep the tail intact. Step 6: You may have stubborn beard hair that needs a bit of touchup, usually found below the chin or on the side of the cheeks. Use a bit of the Beard Setter and apply it directly on to the stubborn hair.